Table of Contents
If you have the Norcold tek ii troubleshooter on your computer, this guide should help you.
Approved
Should
How to connect a DC refrigerator?
Connect the refrigerator directly to the battery. No other switch, wire or electrical deviceshould not use the electrical wiring of the refrigerator as a battery.
If the refrigerator has both AC and DC current, which type does it work with?
When all refrigerators are powered, the default is AC. If the refrigerator is disconnected from shore power and there is very little AC power, the refrigerator will go into DC mode.
Can I connect my AC / DC refrigerator to a regenerator or battery converter?
Do not use tear-off tools or chargers to directly power a specific DC water heater, as these two do not provide filtered DC current.
How quickly should I charge my refrigerator when shopping for food. As soon as I start?
When using the refrigerator for the first time, let it run at the lowest temperature for 8-12 hours before loading food into it. Hot food, high weather conditions and frequent opening of the door will extend the cooling time. Not inBuild plastic, paper and other shelves. If the unit does not start to cool down after two hours, email or call your dealer or Norcold for qualified service information.
How high should the refrigerator be?
Our AC / DC refrigerators (built-in and portable) can operate at angles of up to 30 degrees in both planes.
What does my refrigerator need to be serviced sometimes and especially often?
What should I do if all the doors in my refrigerator do not close properly and I get very cold?
On each dollar-sized sheet of paper, close the door and gently pull on the paper. You should feel some resistance between the gasket and the body. This must be done from all sides of the door. If you don’t feel a slight exhaust on paper, the door really doesn’t close properly. Have the seal on this door repaired by a service center or an authorized Norcold service center.
What to do if the cooler is not cooledis it working properly?
Why is the long intermittent beep disabled?
Using your refrigerator at high ambient temperatures may overheat and prematurely damage the air compressor. To protect the cooling unit from overheating, the refrigerator will turn off when the air temperature in the car rises above 110 degrees Fahrenheit. When a shutdown occurs, a beep sounds from the refrigerator. To silence the alarm and restart the family, turn the thermostat counterclockwise to the OFF position and then clockwise to the desired thermostat position. Refrigerator that won’t start until the room temperature drops below 110 degrees Fahrenheit.
My refrigerator isn’t working and the work light doesn’t even turn green ??
Where do I install my current AC / DC refrigerator?
Approved
The ASR Pro repair tool is the solution for a Windows PC that's running slowly, has registry issues, or is infected with malware. This powerful and easy-to-use tool can quickly diagnose and fix your PC, increasing performance, optimizing memory, and improving security in the process. Don't suffer from a sluggish computer any longer - try ASR Pro today!
The refrigerator should only be installed on a solid wall in the vehicle. Do not load in locations subject to strong shocks and movement.
Can the program damage my portable refrigerator if someone accidentally gets water on it?
Do not place the refrigerator in a place where it may be accidentally filled or sprayed with water that may enter the electrical compartment of the refrigerator.
If you are using a portable refrigerator in an enclosed space, such as a beautiful basement of an apartment building, how much space would be required for ventilation around the drive bay?
Make sure there is a minimum of 3 inches of free space on all three sides of the air compressor compartment and a ventilation area of at least 48 squares above the air compressor compartment. ‘air.
How do I defrost an instant refrigerator?
Turn off the thermostat regulator. Remove all food from the wine cooler. Place dry towels in the refrigerator to absorb excess water. Take out the damp towels and dry them in the refrigerator. Set the temperature controller to the desired value. Return food to refrigerator.
How to buy spare parts?
Spare parts can be purchased from your dealer Or at an authorized Norcold service center.
Your refrigerator will give you years of trouble-free operation whether you do the following simple checks every three to six months. For more information, see the refrigerator operating instructions:
Exit Checklist:
- Keep the food drawer and refrigerator clean. See Cleaning.
- Defrost the refrigerator if necessary. See “Defrosting”.
- Make sure the outer door is tightly closed. See “Door Seal”.
- Pay attention to any cooling changes that are not normally related to weather conditions, load, or thermostat changes. Please contact your dealer or customer service for changes.
- Of course, circulate the air through the cheaper inlet, through the condenser and coils of the wine cooler, and through the top vent, it is not blocked or shrunk.
- Keep the space behind the refrigerator free. Don’t invest in space for the cold A storage grip for storing flammable materials, especially propane and other flammable vapors and liquids.
After completing these checks, if the refrigerator is working, do not contact your dealer or Norcold Authorized Service Center.
- Make sure no switch / thermostat is in the OFF position. Safe
- Make sure the refrigerator is installed correctly and the ventilation holes are not blocked.
- Make sure the shelf life source in the refrigerator is working properly.
- Make sure the circuit breaker or fuse is not damaged (see “About the new protection system”).
- Make sure the ambient temperature is not exceptionally high in most cases (over 110 ° F versus 43 ° C) (see the “Turning off the device in case of overheating” section).
- Make sure the door is closed without asking questions.
- If the weather is very strong, make sure the door closes properly.
- Make sure the moving air in the refrigerator is not limited to food andwhether bookcases covered with plastic, cardboard, etc. Of course
- make sure there is no hot food in the fresh food compartment of the refrigerator.
- Make sure the freezer is defrosted.
Your refrigerator has an over-current protection system where you can see that the electronic circuit must avoid damage so that you can connect the inverter in case of reverse polarity. You need to check the fuse that is in series with the DC connector and the polarity of the specific type of DC power supply.
If the refrigerator does not work frequently, the problem is most likely with the inverter. Have your refrigerator repaired at a new Norcold Authorized Service Center.
The software to fix your PC is just a click away - download it now.
Press and hold the TEMP SET button on the side of the refrigerator control panel. When the section displays “Er”, release the TEMP SET button. When “CL” appears on the display, hold it for five seconds and press the TEMP SET button correctly. However, “He” appears on the screen. Turn the refrigerator off and on again to check if the “no co” error has disappeared.
Check the fuse, which is probably in series with the DC connector, and the polarity of the DC power supply. If the refrigerator still doesn’t work, the problem might be with the inverter. Have your refrigerator type checked by a Norcold Authorized Service Center.
Unplug the refrigerator from the mains.Rotate the refrigerator and freezer using the control panel.Reset the refrigerator freezer and refrigerator temperature settings.Wait in the refrigerator for the temperature to stabilize.
