Home News Resolve The Issue With Microsoft Management Console. The Hard Drive Is Full...

Resolve The Issue With Microsoft Management Console. The Hard Drive Is Full Of Errors

66
0

 

When you see Microsoft Management Console. The hard drive is full of error code on your computer. Read these troubleshooting tips.

 

 

  • 13 minutes to read.
  • Applies to: Windows 10, Windows 8.1, Windows 7, Windows Server (Semi-Annual Channel), Windows Server 2019, Windows Server 2016, Windows Server 2012 R2, Windows Server 2012

    This section lists some common problems you may encounter when using Disk Management, as well as troubleshooting steps.

    Reason

    This issue occurs because the configuration information of the new volume has not yet been written to the hard drive at the time of the power failure.

    Resolution

    To solve the problem, do the following:

    1. Open an elevated command prompt. To do this, click Start, All Programs, Accessories, right-click Command Prompt and select Run as Administrator.

    2. At the command prompt, enter the following command and press Enter: sfc / verifyonly

    3. If the above command returns that problems were found, type the following command and press Enter. Wait until oporder rate:
      sfc / scannnow

    4. microsoft management console. disk is full error

      Open Windows Explorer and navigate to the % Systemroot% inf

      folder.

    5. Check if the volume.inf file has been replaced. If the file is not replaced, you will need to copy volume.inf from another computer with the same version of Windows, the same version of the service pack, and the same processor architecture.

     

     

    How do I get rid of virtual disk service error?

    Two fixes for virtual disk service error – specified disk is not converting
    1. # 1. Convert hard disk to MBR / GPT without data loss.
    2. # 2. Clean up hard drive and convert hard drive to MBR / GPT.

    How do I reset disk management?

    Launch DiskPart
    1. Type diskpart at the command prompt and press Enter.
    2. Enter the list of drives and press Enter to see all mapped drives.
    3. Make sure you know which hard drive to reset before proceeding!
    4. Type select disk # and press Enter (where # is the number of the disk you want to reset)

    How do I remove drive letters in disk management?

    How to remove a drive letter in disk management
    1. Press Win R keys to open Run and type diskmgmt.
    2. Right-click or hold the drive (for example, “G”) whose drive letter you want to delete and click / tap Change drive letter and paths. (
    3. Click / tap the Delete button. (
    4. Click / tap Yes to confirm. (