Table of Contents
In some cases, your system may display the mpk-10cr p2 error message. This error can be caused by a variety of reasons.
Approved
Error Codes | Troubleshooting |
---|---|
P1 | The LCD displays “P1” and the full water indicator blinks every 0.5 seconds. |
P2 | Compressor is not running and “P2” is digitally displayed in the filter area. Bottom shell full |
E1 | Cooling indicator blinks at 1H: and most of the digital display shows the range “E1 inches. The ambient temperature is detected by a side sensor or maintained. |
E2 | The FAN LED flashes quickly 1H: to and the available digital zone shows “E2”. The evaporator temperature sensor is off, this is also called a short circuit. |
E3 | The dehumidification display flashes with 1H: and the digital display segment shows “E3”. Condenser temperature sensor off or short-circuited. |
Troubleshooting
- The Wateriull warning flashes, the water tank is full.
- The weather in the room is
- Ambient temperature. below the set temperature.
- Pour water into running water.
- Reset the temperature.
- Reset the temperature.
- French doors or bedrooms do not have to be closed completely.
- There are heat sources in this room.
- The exhaust duct is poorly connected and clogged.
- The temperature is set too high.
- The air is clogged with dust.
- Make sure windows and doors can be closed.
- Remove heat sources to avoid problems.
- Connect the chain and make sure the site is working properly.
- Decrease the set temperature.
- Clean the air filter.
Possible reasons: not enough space or even not enough space at the time of stopping.
Suggestion to remedy the situation: install the device directly in the apartment. as smooth a surface as possible.
Possible causes: Noise is generated by a certain flow of refrigerant inside the air conditioning system.