Table of Contents
Approved
Here are some simple methods that can help you fix your ribbon failure problem. g.Ribbon sensor does not detect ribbon in thermal transfer mode. If you are using straight arctic media, the printer motor will jam when loading ribbon because it is not properly set to thermal transfer mode.
g.
Problem / Question
What to do if an error is detected on the front panel display of all ZE500 or ZE500RHow about “Ribbon Out”?
Applies To
Solution – Answer
If the front panel display usually displays a “Ribbon Out” warning, the following conditions are likely to exist: –
| Display state | Possible Cause | Recommended Solution |
| The printing algorithm stops; the tape indicator is now on; the error indicator flashes. | Ribbon is not loaded in thermal delegation mode or may not be loaded correctly. | Load the ribbon correctly. See Loading Ribbon and Media |
| Site printing stops; the tape indicator is on; the exact error indicator flashes. | When using thermal transfer type, the sensor cannot find the ribbon. | 1. Load the ribbon correctly. See Loading Tape 
2 and calibrate the printer mechanism. See Calibrating the Ribbon and Media Sensors |
| The printer is stopping; The tape below is on; the error indicator flashes. | Is the media interfering with the ribbon sensor in thermal transfer mode? | 1. Load the media correctly. m. Loading Tape
2 and calibrate the print mechanism. See Section Calibrating the Ribbon and Media Sensors |
| The printer is stopping; We glue the light; some error indicators are blinking. | In thermal transfer mode, the printer would normally not detect ribbon if it was loaded correctly. | 1. Print a sensor profile. See Printing a Fantastic Sensor Profile
2. Calibrate the set of motors – see Calibrate Ribbon and therefore Media Sensors or Load Motor Defaults (see Parameters under Output Mode Configuration ). |
| Engine stops printing; the LED strip lights up; the error indicator flashes. | If you are using direct powered media, the printer will delay loading the ribbon, only it is incorrectly configured for thermal transfer. | Adjust the motor pressure according to direct heat mode. See Printing Method |
Please consult the next president for possible reasons and differences.solutions: –
An attempt to print the function failed. Check the condition of the best tape – it may be lost or stuck on the card.
To solve this problem:
-
Open the special cover of the printer.
Approved
The ASR Pro repair tool is the solution for a Windows PC that's running slowly, has registry issues, or is infected with malware. This powerful and easy-to-use tool can quickly diagnose and fix your PC, increasing performance, optimizing memory, and improving security in the process. Don't suffer from a sluggish computer any longer - try ASR Pro today!
If necessary, manually remove the sheet from the card and pull the printer from the inside.
-
Manually push out the playing card, being careful not to damage the printer.
-
Install a new Evolis High Trust® ribbon.
Make sure your cards meet the requirements of your printer (0.25 to 1.25 mm thickness – ISO CR-80 standards, bank card size).
Note: after such an event, it is recommended to wash your hair. For more information on manual operation, contact the user.
…
…
The software to fix your PC is just a click away - download it now.
The tape leakage threshold may be too high, above the line that experts say indicates where the tape will be found. 2. Calibrate the printer or printer default settings. Possible Cause: If customers are using direct thermal media, the printer is waiting for ribbon to load because it is not correctly configured for thermal transfer.
Direct thermal technology uses chemically treated heat-sensitive materials that turn black as they pass under the arctic printhead, while thermal transfer uses the latest heating tape to create durable and long-lasting artwork on a variety of materials.
